⟁ Wisconsin Well Data field records · 2026 survey

Wisconsin Well Data › Waupaca County › Big Falls (54926)

Big Falls, WI (54926): well depth, water level & drilling cost

✓ 536 WI DNR records · Waupaca County

104 ftmedian well depth
61 ft–245 fttypical depth range
21 ftmedian static water level
15 gpmmedian yield (417 tests)

Pull every recorded well near a Big Falls (54926) address — $49

How deep are wells in and around Big Falls (54926), Wisconsin?

The median drilled well depth in and around Big Falls (54926) is 104 ft, based on 424 wells with recorded depths in the state WI DNR database. Half fall between 61 ft and 245 ft; 90% are shallower than 304 ft.

How much does it cost to drill a well in and around Big Falls (54926)?

Applying published per-foot rates to the local median depth of 104 ft: drilling and casing alone typically runs $2,600–$6,760; a complete system including pump, pressure tank, and hookup typically runs $6,240–$10,400. Actual quotes depend on site access, geology, and casing requirements.

What is the static water level in and around Big Falls (54926)?

The median static water level is 21 ft below ground surface (middle half of wells: 12 ft–32 ft), from 419 measurements.

Drilled depth distribution

0–50 ft 69 50–100 ft 134 100–150 ft 50 150–200 ft 36 200–300 ft 88 300–400 ft 42 400–600 ft 5 600+ ft 0
Looking at a specific property in Big Falls (54926)?

See every recorded well near any address — depths, water levels, yields, original driller's logs — in a one-time report.

Free lookup Property report — $49
Get quotes from drillers who work in Big Falls (54926)

Free. Goes to licensed drillers working Waupaca County.

Part of Waupaca County well records.

Method: medians computed from WI DNR records (drilled water wells (well-construction reports) — geothermal loop/heat-exchange, anode, test and dry holes excluded; depths 0–5,000 ft), grouped by ZIP from the recorded address. Cost estimate applies published per-foot ranges to the local median depth — full methodology & sources.